An orange cat sleeps on a neatly made bed with dark grey bedding in a minimalist bedroom with wall sconces and a mounted air conditioner.

Mini Split Installation in Broken Arrow, OK

A new system here will heat from October through April and cool from May through September every year. Tell us about the house, and a licensed contractor who covers Wagoner County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A minimalist bedroom with dark grey walls, a large bed with charcoal bedding, a sleeping cat, two warm-toned wall sconces, and a wall-mounted air conditioning unit.

Broken Arrow asks for heat and cooling both, almost year round

A mini-split here works nearly every month. Winter nights average 30°F from December through February, and summer afternoons average 91°F, so the same unit has to handle both ends without a break. Heat is needed October through April, seven months, and cooling runs May through September, another five. That is 12 months of one system or the other.

Any mini-split installed new has to meet the federal minimum for a split-system heat pump, 14.3 SEER2 for cooling and 7.5 HSPF2 for heating. With power outages affecting a quarter of Oklahoma households last year, and this area seeing 8 winter storms and 84 damaging wind events over the past ten years, a mini-split sized and installed to hold up through both seasons matters more here than in places with a shorter list to cover.

7 months
October through April, your system heats
5 months
May through September, it cools
30°F
the average winter night it heats against
91°F
the average summer afternoon it cools against
Isometric cutaway illustration of a gray house showing two wall-mounted indoor air conditioning units in separate rooms with furniture, connected by line sets to an outdoor condenser unit on a pad outside.
Your system heats October through April and cools May through September.

NOAA nClimDiv, 1991–2020 normals

Oklahoma requires HVAC contractors to hold a state license.

The Construction Industries Board issues that license after testing the contractor, and it keeps a record of who holds one. The license belongs to the business, not to any single job, so it stays in effect across every install or repair that contractor takes on in Wagoner County.

For a mini-split install, that license is what stands behind the work. Alongside it, most cities and counties here require a permit for this kind of installation, along with an inspection once it's done, so someone from the local building office checks the work independent of the contractor doing it.

Source: Oklahoma State Legislature

Is a mini split worth it?
For the right room or house, yes. A mini split heats and cools without ducts, so it works well for additions, garages, or older homes that never had ductwork run to every room. Broken Arrow winters drop to 30°F on average and summers climb to 91°F, and a mini split is built to handle both, so you're not running separate heating and cooling equipment. Whether it makes sense for your house depends on how it's laid out and what's heating and cooling it now, and a contractor can walk through that with you.
How many rooms can a mini split cover?
One outdoor unit can run anywhere from one indoor head up to eight, depending on the system. A single-zone setup covers one room or open area. A multi-zone system runs several indoor heads off one outdoor unit, so you can put one in a bedroom, one in a living room, and so on, each with its own thermostat. How many rooms yours should cover comes down to the size and layout of the house, which is something a contractor will size on site.
Can a mini split heat a whole house?
It can, if there are enough indoor heads placed to reach every room. A multi-zone mini split ties several indoor units to one outdoor unit, and each zone heats the space it's in. Broken Arrow needs heat from October through April, seven months of the year, so the system has to be sized for those 30°F winter nights, not just mild days. Getting that right for a whole house takes a room-by-room look, which is what a contractor's site visit is for.