Furnace Installation in Broken Arrow, OK
A new furnace here will run from October through April every year. Tell us about the house, and a licensed contractor who covers Wagoner County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, on nights near freezing
Broken Arrow homes need a working furnace from October through April. That's seven months of the year, with winter nights averaging 30°F. A new furnace here has to start easily and hold up to months of steady use, not just a few cold snaps.
Most homes in this area heat with gas, and any non-weatherized gas furnace built since November 2015 has to reach at least 80 percent AFUE. That's the federal floor, not a target, so it's worth knowing where the unit going into your home stands above it.
- 7 months
- October through April, your furnace is on duty
- 30°F
- the average winter night it heats against
- 60%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $90 a year to run in Wagoner County compared with a gas furnace.
Estimates for a typical Wagoner County home, from EIA household energy data, Oklahoma fuel prices and NOAA climate normals. Your home will differ.
Oklahoma requires HVAC contractors to hold a state license.
The Construction Industries Board tests contractors before it issues this license, and the license belongs to the contractor rather than to any single job. That is the state's check on who is allowed to install a furnace in Oklahoma.
This license covers the contractor, not the installation itself. Most cities and counties also require a permit from the local building office for a furnace installation, with an inspection once the work is done, and that permit is what puts a check on this specific job. In Wagoner County, 59.9% of homes heat with gas.
Source: Oklahoma State Legislature
- What size furnace does my house need?
- The right size depends on your square footage, your insulation, your ceiling height, and how many windows you have facing north. A furnace that's too big will short cycle, turning on and off before it heats evenly. One that's too small will run constantly and still leave rooms cold during the winter. A contractor works this out with a load calculation, not a chart based on square footage alone, since two homes the same size can need different furnaces.
- How do I know it's time to replace my furnace?
- Watch for rising repair bills, uneven heat between rooms, and a furnace that runs longer than it used to just to hold the same temperature. Furnaces wear out over time, and older units get harder to find parts for, so failures start coming more often. If yours needs heat every month from October through April here and a repair keeps failing, that is a sign to stop patching it. A contractor can tell you whether what you're seeing points to a fix or a replacement.
- Is a high-efficiency furnace worth it?
- It depends on how long you plan to stay in the house and what your current furnace costs to run. Every new non-weatherized gas furnace sold since November 2015 has to hit at least 80 percent AFUE, so even a standard replacement today is more efficient than an older unit. High-efficiency models push that number higher, which matters more here since homes need heat seven months of the year. Whether the higher price pays off for your situation is something a contractor can walk through with you using your actual furnace and your actual gas bills.