Furnace Repair in Claremore, OK
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Rogers County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of work, on nights near freezing
Your furnace runs October through April in Claremore, seven months of the year. Winter nights average 29°F from December through February, so the burner is lighting and shutting off many times a day to keep up. Each start puts a little wear on the igniter and the flame sensor, and over enough winters that wear catches up with the parts.
Storms add another layer here. Rogers County has seen 10 winter storms and 109 damaging wind events over the last ten years, and in 2024, a quarter of Oklahoma households went at least 24 hours without power. A gas furnace still needs electricity to fire the igniter and run the blower, so when the power drops, the furnace stops with it.
- 7 months
- October through April, your furnace is on duty
- 29°F
- the average winter night it heats against
- 56%
- of homes here heat with gas, so most furnaces here burn gas
- 10 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $110 a year off heating for a typical Rogers County home.
Estimates for a typical Rogers County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Oklahoma fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
Oklahoma requires HVAC contractors to hold a state license.
The Construction Industries Board tests contractors before issuing that license and keeps a record of who holds one. It's issued to the contractor, not to each job, so the same license covers the work whether it's a furnace repair or something else in the house.
For a furnace repair, that license is what stands behind the person working on your gas line and burner assembly. A bad gas connection is the real danger in this kind of job, and the license is the state's way of saying this contractor has been checked before being trusted with it. In Rogers County, 55.9% of homes heat with gas, so that repair is a common one here.
Source: Oklahoma State Legislature
- Why won't my furnace turn on?
- Start with the thermostat. If the display is blank or won't respond, check the batteries first, then the breaker. If the thermostat is fine, the furnace itself may not be getting power, so check the breaker and the furnace's own switch, which looks like a light switch near the unit. If it still won't start, the igniter or the flame sensor is often the cause, and a contractor can test which one it is.
- Why is my furnace blowing cold air?
- Most often the blower is running before the burners have lit, which feels cold for a minute but is normal. If cold air keeps coming and never warms up, the igniter may not be lighting the burners, or the gas valve isn't opening. A dirty filter can also block enough airflow that the furnace shuts the burners off to protect itself. Check the filter first, then have a contractor look at the igniter and gas valve if that doesn't fix it.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple has worn out and can no longer sense the pilot flame, so the gas valve shuts it off. A draft blowing across the pilot, or a dirty pilot orifice, can cause the same thing. A standing pilot doesn't use power to run, so this has nothing to do with an outage. A contractor can test the thermocouple and replace it if that's the problem.