Furnace Repair in Bartlesville, OK
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Washington County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of Bartlesville winters wear on your furnace
Your furnace works from October through April here, seven months of the year. On winter nights that average 27°F, it cycles on and off for hours at a stretch to keep the house warm, and each start puts wear on the igniter. A weak one will stop lighting the burner before long, and the house goes cold.
Washington County has seen 7 winter storms and 56 damaging wind events over the past ten years. A quarter of Oklahoma households lost power for at least a day in 2024, and when that happens in the middle of a cold snap, a furnace that was already struggling can fail to start back up on its own.
- 7 months
- October through April, your furnace is on duty
- 27°F
- the average winter night it heats against
- 63%
- of homes here heat with gas, so most furnaces here burn gas
- 7 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $110 a year off heating for a typical Washington County home.
Estimates for a typical Washington County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Oklahoma fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
Oklahoma requires HVAC contractors to hold a state license.
The state issues this license through the Construction Industries Board, and it belongs to the contractor, not to any single job. The same license covers every furnace they touch, not just this one, and it is the state's record that they were tested and can be held accountable for their work.
For a furnace repair, that license is what stands behind the work. Most homes in Washington County heat with gas, and gas is the part of the job with real consequences if a connection is made wrong. The Construction Industries Board license is what says the contractor was tested to get that part right.
Source: Oklahoma State Legislature
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way it should, or power to the furnace has been cut off somewhere. Check that the thermostat is set above room temperature and has working batteries. Then check the furnace switch, the breaker, and the door panel, since most furnaces won't run at all if that panel isn't seated right. If those all check out, the igniter or a safety switch inside the furnace may be at fault, and that calls for a contractor to test it.
- Why is my furnace blowing cold air?
- A furnace blows cold air for a few minutes when it first starts, while it warms up before the blower kicks in. If cold air keeps coming the whole time it runs, the burners likely aren't lighting even though the fan is. That points to an igniter or gas valve problem, not the fan itself. A dirty filter can also cause short cycling that feels like cold air, so check the filter before anything else.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple isn't sensing the flame anymore, so the safety valve shuts the gas off after a few seconds. It can also mean a draft is blowing the pilot out, or the pilot orifice is partly clogged. Homes here rely on gas heat more than most, with 62.8% of Washington County homes heating this way, so a pilot that won't hold is worth getting looked at before the next cold night. Only a licensed contractor should adjust or replace the thermocouple, since it's a gas safety part.