HVAC Repair in Skiatook, OK
Homes here need heat from October through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Osage County will get in touch.
Tell us about the job
It takes about a minute.
Skiatook runs its system almost every month of the year
Heat runs October through April here. Cooling takes over for May through September. That leaves your furnace and your air conditioner covering nearly all twelve months between them, with barely a break for either one to rest.
Winter nights average 27°F, cold enough that the burner cycles on and off for hours to keep up. Summer afternoons hit 90°F, and the compressor runs long stretches to keep the house down. Both put real wear on the parts that start the system, the igniter on the furnace side and the capacitor on the AC side. A quarter of Oklahoma households went at least 24 hours without power in 2024, and a system that will not restart on its own once power comes back leaves a house cold or hot until someone deals with it.
- 7 months
- October through April, your system heats
- 5 months
- May through September, it cools
- 27°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $160 a year off heating and cooling for a typical Osage County home.
Estimates for a typical Osage County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Oklahoma fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
Oklahoma requires HVAC contractors to hold a state license.
The Construction Industries Board issues that license, and getting one means the contractor was tested on the trade before the state put their name on record. The license belongs to the contractor, not to any single job, so it covers them across every call, not just this one.
For a repair job like this one, that license is what stands behind the work. It's the state's record that the person working on your furnace or air conditioner was tested on the trade before they were allowed to take the job.
Source: Oklahoma State Legislature
- Why is my heat not working?
- A few things cause this, and most of them start with the thermostat and the pilot or igniter. Check that the thermostat is set to heat and the temperature is above room temperature, and check that the furnace has power at the breaker. If it has a standing pilot, look for the flame. If the igniter is electronic and it fails to light, the furnace will usually try a few times and then lock out, and at that point it needs a contractor. With winter nights here averaging 27°F, a furnace that will not start is not something to leave for later.
- Why is my system running but not cooling the house?
- The system running but not cooling usually means air is not moving through the house or the refrigerant side has a problem. Start with the filter. A clogged filter chokes airflow and the coil can ice up behind it, which stops cooling even though the blower still runs. If the filter is clean and the vents are open but the air coming out does not feel cold, the system likely has a refrigerant leak or a failing part, and that is a contractor's job to find. On a 90°F afternoon this shows up fast, since the system has less time to catch up.
- What can I check before calling for HVAC repair?
- Check the thermostat first. Make sure it is set correctly, has fresh batteries if it uses them, and is calling for heat or cooling as expected. Check the breaker for the system, since a tripped breaker looks like a dead system but takes seconds to fix. Check the filter and swap it if it is dirty, since a blocked filter causes problems that look like bigger failures. If the outdoor unit is covered in debris or the vents inside are blocked by furniture, clear them. If none of that solves it, a licensed contractor will need to look at the actual equipment, since Oklahoma requires a state license to do that work.