HVAC Repair in Norman, OK
Homes here need heat from November through April and cooling from May through September. If your system quits, tell us what it's doing and a licensed contractor who covers Cleveland County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of work a year in Cleveland County
Your system in Norman gets almost no rest. Heat runs November through April, then cooling takes over for May through September. That's eleven months where the furnace or the AC is doing real work, and only a few weeks in between where it just sits.
Winter nights averaging 30°F mean the burner cycles on and off for hours, and each start puts wear on the igniter. Summer afternoons averaging 92°F push the compressor hard for months straight, and that heat is what wears down a capacitor or strains a weak connection until it fails. Add the wind. Cleveland County has seen 163 damaging wind events in the last ten years, and a quarter of Oklahoma households lost power for at least a day in 2024. When the power drops and comes back, most systems restart on their own, but a unit that was already struggling can go down for good on that restart.
- 6 months
- November through April, your system heats
- 5 months
- May through September, it cools
- 30°F
- the average winter night it heats against
- 92°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $150 a year off heating and cooling for a typical Cleveland County home.
Estimates for a typical Cleveland County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Oklahoma fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
Oklahoma requires HVAC contractors to hold a state license.
The license comes from the Construction Industries Board, and it means the contractor was tested before being allowed to take on this kind of work. It attaches to the contractor, not to any single job, so the same license covers this repair and every other one they take on.
For a heating and cooling repair, that license is what stands behind the work. It is the state's record that the contractor met the standard to do this job, not just this one.
Source: Oklahoma State Legislature
- Why is my heat not working?
- Start with the thermostat. Check that it is set to heat and the temperature is set above the room temperature, and check the batteries if it has a screen that looks dim. If the thermostat looks fine, check the breaker for the furnace or air handler, since a tripped breaker will shut the whole system down. Gas furnaces will not fire if the pilot is out or the igniter has failed, and that calls for a contractor. With winter nights here averaging 30°F, a furnace that will not start is worth getting looked at the same day.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust blocks airflow across the coil, and the coil can ice up when that happens, which makes the problem worse the longer the system runs. Next check that all the vents in the house are open and nothing is blocking them. If the filter is clean and the vents are open and the air coming out still feels warm, the refrigerant charge or the outdoor unit needs a contractor to look at it. On a 92°F afternoon a system that runs constantly without cooling the house is losing ground, not gaining it, so it is worth shutting off rather than letting it run.
- What can I check before calling for HVAC repair?
- Check the thermostat settings and batteries first, then the breaker for the furnace or outdoor unit, then the air filter. These catch a real share of no-heat and no-cool calls on their own. Storms come through this area often enough that a tripped breaker after high wind is worth checking before anything else. Beyond that, a contractor licensed through the Construction Industries Board will need to diagnose it, since opening the cabinet on a furnace or handling refrigerant is not something to do without training.