Furnace Repair in Enid, OK
Furnaces here run from October through April. If yours quits, tell us what it's doing and a licensed contractor who covers Garfield County will get in touch.
Tell us about the job
It takes about a minute.
Seven months of heat, and nights that stay near 27°F
Furnaces in Enid run from October through April. That is seven months of the burner lighting and shutting off, night after night, to keep up with winter lows that average 27°F. Each cycle puts the same load on the igniter and the flame sensor, and over a season that adds up fast.
Garfield County has logged 12 winter storms and 109 damaging wind events over the past ten years. Wind and ice both put a strain on the power grid, and statewide, a quarter of households went at least 24 hours without power in 2024. A furnace that loses power will not restart on its own. You will notice a house that stays cold even after the lights come back on, until the furnace is reset or looked at.
- 7 months
- October through April, your furnace is on duty
- 27°F
- the average winter night it heats against
- 61%
- of homes here heat with gas, so most furnaces here burn gas
- 12 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $120 a year off heating for a typical Garfield County home.
Estimates for a typical Garfield County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Oklahoma fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
Oklahoma requires HVAC contractors to hold a state license.
The Construction Industries Board tests and licenses the contractor, not the individual repair job. That means the license on record covers the person or company doing the work, so it follows them from house to house rather than getting issued fresh each time someone opens up a furnace.
For a furnace repair, that license is what stands behind the work. A gas furnace has a burner and a flue, and a loose connection or a bad seal is the part that can hurt someone, so the license is what tells you the contractor has been checked against the state's standard before they touch it. In Garfield County, 60.5% of homes heat with gas, which is the kind of repair this license was built to cover.
Source: Oklahoma State Legislature
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way it should, or power isn't reaching the furnace. Check that the thermostat is set below room temperature and has fresh batteries if it uses them. Next check the furnace switch, the one that looks like a light switch near the unit, and the breaker for it in your panel. If those are fine, the igniter or a safety switch inside the furnace may have failed, and that calls for a contractor to open it up and test it.
- Why is my furnace blowing cold air?
- A furnace blows cold air for a few seconds when it first starts, while it clears cool air out of the ducts, and that's normal. If it keeps blowing cold or never warms up, the burners may not be igniting even though the blower is running. A clogged filter can also cause this by starving the burners of airflow, so check the filter first. If the filter is clean and you're still getting cold air, the igniter, flame sensor, or gas supply needs a contractor to look at it.
- Why won't my furnace pilot light stay lit?
- This usually means the thermocouple, the small safety sensor next to the pilot flame, has worn out and is shutting the gas off even when the flame is lit. A draft blowing across the pilot can also snuff it out, so check for airflow near the burner compartment. If you relight it and it goes out again within a minute or two, the thermocouple is the likely cause and a contractor will need to replace it. Don't keep relighting it repeatedly if it won't hold, since that points to a part that needs replacing, not a fluke.